Diagnostic Commercial Fleet Diagnostics JPRO [11.2022] + Activación 1PC 2022v3

Update

WHAT'S NEW
2022 V3 FEATURE UPDATES

•ADAS displays faults and data from related components to assist in troubleshooting Advanced Driver Assistance System issues.

Engine Support

Heavy-Duty Support for Detroit:

• Bi-Directional support for Detroit Diesel engines includes:
◦ NOTE: JPRO must connect and identify the correct Detroit Diesel engine module software versions (CPC, MCM, and/or ACM) to enable bi-directional support. Tests are not available if the correct software versions are not identified.
◦ Cruise Speed Limits (Max/Min Cruise Set Speed) now supports GHG17 and newer DD5, DD8, DD13, DD15, and DD16 with
Engine Software Version: App_3105, App_3106, App_3107, App_3108
◦ Cylinder Cut Out now supports GHG17 and newer DD5, DD8, DD13, DD15, and DD16 with Engine Software Version: App_3108 | MCM Software Version: mcm_0x06F6
◦ DEF Coolant Valve Control Test now supports GHG17 and newer DD5, DD8, DD13, DD15, and DD16 with MCM Software Version: mcm_0x06F6
◦ DEF Face Plug Cleaning now supports GHG17 DD5, DD8, DD13, DD15, and DD16 with MCM Software Version:
mcm_0x06F6
◦ DPF Ash Accumulator Reset now supports GHG17 and newer DD5, DD8, DD13, DD15, and DD16 with MCM Software Version: mcm_0x06F6
◦ DPF Service Regen now supports GHG17 and newer DD5, DD8, DD13, DD15, and DD16 with Engine Software Version: App_3105, App_3106, App_3107, App_3108 | GHG17 and newer DD5, DD8, DD13, DD15, and DD16 with ACM Software Version: acm_0x0211, acm_0x0213, acm_0x0221, acm_0x0232, acm_0x0236, acm_0x023E, acm_0x024E,
acm_0x0250, acm_0x0354, acm_0x0359
◦ Hydrocarbon Doser Purge now supports GHG17 and newer DD5, DD8, DD13, DD15, and DD16 with MCM Software Version: mcm_0x06F6
◦ Idle Shutdown (Idle Shutdown Status, Idle Shutdown Speed) now supports GHG17 DD5, DD8, DD13, DD15, and DD16 with
Engine Software Version: App_3105, App_3106, App_3107, App_3108
◦ Performance Check Low Temp ATD now supports GHG17 and newer DD5, DD8, DD13, DD15, and DD16 with MCM Software Version: mcm_0x06F6
◦ PTO Parameters [General PTO (Config PTO Speed control, PTO Remote Throt Override Mode, Throttle Override Max Eng Speed, PTO Dropout Serv Brk Prk Brk, PTO Dropout on Clutch Enabled, Max Road Speed in PTO Mode, PTO Ramp Rate, PTO Cab Switches Mode, PTO Accel Pedal Override Mode, RPM Increment) | Cab PTO (Min PTO Spd Set Coast Sw, Max PTO Spd Resume Accel Sw, Set Coast Switch PTO Speed, Resume Accel Switch PTO Speed)
| Remote PTO (Remote PTO Spd Selection Mod, No of Speeds Via Remote PTO, Spd 1 Via Remote PTO, Spd 2 Via Remote PTO, Spd 3 Via Remote PTO)
| Inputs (2 08 DI Selection, 2 09 DI Sw Config (EPA 10 Only), 2 09 DI Selection (EPA 13 only), Remote Accelerator Enable)] now supports GHG17 DD5, DD8, DD13, DD15, and DD16 with Engine Software Version: App_3105, App_3106, App_3107, App_3108
◦ Road Speed Limits Maximum Road Speed Limit now supports GHG17 and newer DD5, DD8, DD13, DD15, and DD16 with
Engine Software Version: App_3105, App_3106, App_3107, App_3108
◦ SCR Output Component Test now supports GHG17 and newer DD5, DD8, DD13, DD15, and DD16 with MCM Software Version: mcm_0x06F6
◦ VSS Parameters [Vehicle Speed Sensor, Axle Ratio, Tire Revs Per Unit Distance, Top Gear Ratio, Second Highest Gear Ratio, Number of Output Shaft Teeth, Anti Tamper, VSS Absolute Diagnostics Limit (EPA 13 only), VSS Driving Diagnostic Limit (EPA 13 only), Wheel Revs Front Axle NR (EPA 13 only)] now supports GHG17 and newer DD5, DD8, DD13, DD15, and DD16 with MCM Software Version: mcm_0x06F6
◦ NOTE: To see Software Version, select the engine and look in the bottom left of JPRO.

Brake Manufacturer Support


Bendix Tractor Brakes:


• Supports proprietary sensor data on ADB Continuous Wear Sensing ECUs.

• Displays percentage of estimated brake wear life (pads plus rotor) remaining on the ADB Continuous Wear Sensing key data points window.
• Bendix DTC Report VIN table updated to support VINs from SAE and proprietary sources.

Bendix Trailer Brakes:

• Supports proprietary sensor data for TABS-6™ Advanced Single-Channel Trailer ABS.

• Bendix Trailer DTC Report provides comprehensive reporting for trailer connections.

• Supports trailer diagnostics over CAN for TABS-6™ Advanced Single-Channel Trailer ABS modules using the Bendix 4-pin to 9-pin diagnostics extension cable.
• The EOL (End of Line) Test now supports TABS-6™ Advanced Single-Channel Trailer ABS. It provides a suite of tests used to validate if the ABS and its sensors are installed and functioning properly.
◦ EOL Test report provides general ECU information, test results, and information gathered by individual tests.
◦ Select the EOL tests to be run and the order to perform them in using the new Customize button.
◦ Individual EOL tests are also available from the bi-directional test menu.

• Bi-Directional support for Bendix Trailers:
◦ ABS Indicator Lamp Test supported on TABS-6™ Advanced Single-Channel Trailer ABS
◦ Axle Load Test supported on TABS-6™ Advanced Single-Channel Trailer ABS
◦ Battery Voltage Test supported on TABS-6™ Advanced Single-Channel Trailer ABS
◦ Chuff Test supported on TABS-8™ Trailer ABS
◦ Door Switch Test supported on TABS-6™ Advanced Single-Channel Trailer ABS
◦ ECU Information Test* supported on TABS-6™ Advanced Single-Channel Trailer ABS
◦ General Output Functions Test supported on TABS-6™ Advanced Single-Channel Trailer ABS
◦ Installation Angle Test supported on TABS-6™ Advanced Single-Channel Trailer ABS
◦ Installation Configuration Test supported on TABS-6™ Advanced Single-Channel Trailer ABS
◦ Lift Axle Control Test supported on TABS-6™ Advanced Single-Channel Trailer ABS
◦ NOTE: Supports LAS1 and LAS2.
◦ Lift Axle Sensing Test supported on TABS-6™ Advanced Single-Channel Trailer ABS
◦ NOTE: Supports LAS1 and LAS2.
◦ Lift Lower Test supported on TABS-6™ Advanced Single-Channel Trailer ABS
◦ Low Pressure Warning Emergency Test supported on TABS-6™ Advanced Single-Channel Trailer ABS
◦ Low Pressure Warning Service Test supported on TABS-6™ Advanced Single-Channel Trailer ABS
◦ P-21 Delivery Test supported on TABS-8™ Trailer ABS
◦ P-21 Modulator Test supported on TABS-6™ Advanced Single-Channel Trailer ABS
◦ Pad Wear Test supported on TABS-6™ Advanced Single-Channel Trailer ABS
◦ Pressure Sensor Test supported on TABS-6™ Advanced Single-Channel Trailer ABS
◦ S-C and S-D Sensor Tests supported on TABS-6™ Advanced Single-Channel Trailer ABS
◦ Scratchpad Test* supported on TABS-6™ Advanced Single-Channel Trailer ABS
◦ Tire Inflation System Test supported on TABS-6™ Advanced Single-Channel Trailer ABS
◦ Wheel Speed Chart Test all braking systems reporting wheel speed values
◦ Wheel Speed Window Test all braking systems reporting wheel speed values
* Test only displayed within the Installation Test dialog.

Bendix Driver Assistance Systems (DAS):


• Supports reading and clearing Bendix Fault Codes and reading sensor data on:
◦ AutoVue® FLC25™ Camera

• Bi-Directional support for Bendix Driver Assistance Systems:
◦ Wingman FLR Configuration [General Settings (ACC Lateral Mounting Offset, Highway Departure Braking, ACC Type, Multi Lane AEB,
ACC Type Engine Mismatch) | DFA Alerts/Following Distance Settings (Following Distance Alert Table, Momentary FDA)] supported on Wingman® FLR25™ Radar

Bendix Tire Pressure Monitoring System (TPMS):


• TPMS Configuration test provides data reset warning for Learn All Sensors function.

Wabco Advanced Driver Assistance Systems (ADAS):


• Supports SAE faults and proprietary sensor data for OnGuard™ Forward Looking Radar.

Transmission Support



Heavy-Duty Support for Detroit:


• Bi-Directional support for Detroit Diesel transmissions:
◦ Transmission Learn Procedure Test supported on DT12 TCM01T Transmissions

JPRO® MEDIUM-DUTY FEATURES


Medium-Duty Support for GM:


• Updated support for the following vehicles: 2022 GMC and Chevy Full Sized Trucks 1500, 2500 and 3500, 2022 GMC Express and Chevy Savana, 2022 GMC Canyon and Chevy Colorado.
◦ NOTE: Only the powertrain components are supported on 2014 and newer GM vehicles.

• Fixed issue causing Freightliner vehicles with GM engines to misidentify the engine.

• Bi-Directional support for GM engines:
◦ Cylinder Cut Out now supports 2022 all diesel and gasoline engines (except GM vehicles with CAT engines).
◦ DPF Catalyst Reset now supports 2022 vehicles with Duramax 6.6L diesel engines, 2022 GMC and Chevy Express or Colorado with a 2.8L Diesel engine.
◦ DPF Pressure Sensor Reset now supports 2022 vehicles with Duramax 6.6L diesel engines, 2022 GMC and Chevy Express or Colorado with a 2.8L Diesel engine.
◦ DPF Service Regen now supports 2022 vehicles with Duramax 6.6L diesel engines, 2022 GMC and Chevy Express or Colorado with a 2.8L Diesel engine.

GENERAL FEATURES


• Updated support for VIN decoding of North American VINS.

• Updated and expanded Spanish language support.
◦ NOTE: Fault descriptions are not supported for translation.

Education and Troubleshooting Features:


• Most Likely Repair, available from Repair Mentor and Fault Guidance, provides information on the most frequent repairs for
a fault.
◦ NOTE: Requires internet access.

• Possible Unrepaired Recalls, available from Repair Mentor and Fault Guidance, provides detailed information on possible NHTSA recalls for the connected vehicle:
◦ NOTE: Requires internet access.
• Bendix Service Data Sheets now include Active Steering by Bendix CVS.
◦ NOTE: Maintenance or Service Data Sheets for Bendix are only available when JPRO® Professional Diagnostic Software with NextStep™ is the purchased product.

• Bendix Demo Truck now supports the following ECU options:
◦ FLC now supports AutoVue® FLC25™ Camera
◦ ADB Wear Sensing now supports ADB Wear Sensing and ADB Continuous Wear Sensing
◦ NOTE: This is for demonstration purposes only. Tests and data may not function realistically.

Product Support Features:


• Fixed issue preventing uninstall after a full upgrade.